Maximum availability

Configuration. Double conversion on-line UPS with automatic by-pass and power factor correction.
Continuous power supply. Hot swappable batteries. The HotSwap MBP (Maintenance By-Pass) module allows the battery to be replaced without interrupting the power supply.

View Hot Swap Maintenance
Bypass Demo

Redundancy. The ModularEasy kit makes it easy to parallel 2 standard Pulsar M UPSs (N + 1 redundancy).

View ModularEasy Demo

Powershare. The Pulsar output sockets are individually controlled to provide load-shedding to maximise the backup time. It also provides remote reboot and sequential start-up as standard.
Long backup times. 1 to 4 EXB battery units can be added to the Pulsar M. The Pulsar 3000XL has a built-in high speed charger for additional long backup times.

Minimum total cost of ownership

ModularEasy kit. A simple, low cost solution for uprating by adding a second standard UPS.
Easy operation. Multilingual display. Access to a wide range of measurements and set-up menus.
Remote supervision. A wide range of options using the Solution-Pac supplied: SNMP and HTML, (Network Management Card included with Netpack versions), ModBus/JBus and relay outputs.

Totally adaptable

Format. Pulsar M is available in RT2U convertible rack/tower version (optimised for rack mounting) or RT3U (for tower or shallow rack).
Connections. With FlexPDU and HotSwap MBP the Pulsar M can be connected by sockets or terminal blocks. They can be installed as required behind, on the side or on top of the unit.

View FlexPDU/HotSwap MBP
Installation Demo

Compatible with high power factor loads. Pulsar M is rated for 0.9 total power factor
Interfaces. USB + serial + remote start/stop + slot for optional communications card.